# Pastebin FIHTP9Yb GXL:BL1:9ac50e:bb16dc;FEAT:ADFC318C:0;POC:3;RCY:0;EMMC:0;READ:0;0.0;CHK:0; TE: 74300 BL2 Built : 20:22:19, Aug 18 2017. gxl gfa7a104 - xiaobo.gu@droid12 set vcck to 1120 mv set vddee to 1000 mv Board ID = 2 CPU clk: 1200MHz DQS-corr enabled DDR scramble enabled STICKY_REG0: 0x00000000 STICKY_REG1: 0x00000000 STICKY_REG9: 0x00000000 DDR3 chl: Rank0 16bit @ 660MHz p_ddr_set->ddr_size = 0 p_ddr_set->ddr_size = 2048 Rank0: 2048MB(auto)-2T-9 DataBus test pass! AddrBus test pass! -s Load fip header from eMMC, src: 0x0000c200, des: 0x01400000, size: 0x00004000 New fip structure! Load bl30 from eMMC, src: 0x00010200, des: 0x01100000, size: 0x0000d600 Load bl31 from eMMC, src: 0x00020200, des: 0x05100000, size: 0x0002c600 Load bl33 from eMMC, src: 0x00050200, des: 0x01000000, size: 0x00066c00 NOTICE: BL3-1: v1.0(release):a625749 NOTICE: BL3-1: Built : 11:25:15, Aug 25 2017 [BL31]: GXL CPU setup! NOTICE: BL31: BL33 decompress pass mpu_config_enable:ok [Image: gxl_v1.1.3242-f21d6ea 2017-08-08 12:09:41 qiufang.dai@droid07] OPS=0xa4 66 a6 24 75 2f 87 de da a 44 9e 51 [0.309407 Inits done] secure task start! high task start! low task start! ERROR: Error initializing runtime service opteed_fast U-Boot 2015.01-g2d1a155-dirty (Oct 11 2017 - 17:16:27) DRAM: 2 GiB Relocation Offset is: 76eb0000 register usb cfg[0][1] = 0000000077f58e98 [CANVAS]canvas init boot_device_flag : 1 Nand PHY Ver:1.01.001.0006 (c) 2013 Amlogic Inc. init bus_cycle=6, bus_timing=7, system=5.0ns reset failed get_chip_type and ret:fffffffe get_chip_type and ret:fffffffe chip detect failed and ret:fffffffe nandphy_init failed and ret=0xfffffff1 MMC: aml_priv->desc_buf = 0x0000000073eb06b0 aml_priv->desc_buf = 0x0000000073eb29d0 SDIO Port B: 0, SDIO Port C: 1 emmc/sd response timeout, cmd8, status=0x1ff2800 emmc/sd response timeout, cmd55, status=0x1ff2800 init_part() 293: PART_TYPE_AML [mmc_init] mmc init success dtb magic edfe0dd0 Amlogic multi-dtb tool Single dtb detected start dts,buffer=0000000073eb5200,dt_addr=0000000073eb5200 Amlogic multi-dtb tool Single dtb detected parts: 3 00: logo 0000000000800000 1 01: ramdisk 0000000002000000 1 02: rootfs ffffffffffffffff 4 init_part() 293: PART_TYPE_AML eMMC/TSD partition table have been checked OK! check pattern success mmc env offset: 0x7400000 In: serial Out: serial Err: serial reboot_mode=cold_boot [store]To run cmd[emmc dtb_read 0x1000000 0x40000] _verify_dtb_checksum()-917: calc d7ae398, store d7ae398 _verify_dtb_checksum()-917: calc d7ae398, store d7ae398 dtb_read()-1039: total valid 2 dtb_read()-1106: do nothing Amlogic multi-dtb tool Single dtb detected vpu: clk_level in dts: 7 vpu: set clk: 666667000Hz, readback: 666660000Hz(0x300) vpu: vpu_clk_gate_init_off vpp: vpp_init hpd_state=0 cvbs performance type = 6, table = 0 setenv ddrclk 666 MHz Net: dwmac.c9410000 Start read misc partition datas! _find_partition_by_name()-188: do not find match in table misc Cannot find dev. amlmmc cmd failed store - STORE sub-system Usage: store store init flag store read name addr off|partition size read 'size' bytes starting at offset 'off' to/from memory address 'addr', skipping bad blocks. store write name addr off|partition size write 'size' bytes starting at offset 'off' to/from memory address 'addr', skipping bad blocks. store rom_write add off size. write uboot to the boot device store erase boot/data: erase the area which is uboot or data store erase partition : erase the area which partition in u-boot store erase dtb store erase key store disprotect key store rom_protect on/off store scrub off|partition size scrub the area from offset and size store dtb iread/read/write addr read/write dtb, size is optional store key read/write addr read/write key, size is optional store mbr addr update mbr/partition table by dtb [burnup]Err:store_read_ops,L63:cmd failed, ret=1, [store read misc 0x73e9f470 0x0 0x440] failed to store read misc. info->attemp_times = 0 info->active_slot = 0 info->slot_info[0].bootable = 0 info->slot_info[0].online = 0 info->slot_info[1].bootable = 0 info->slot_info[1].online = 0 info->attemp_times = 0 boot-info is invalid. Resetting. save boot-info info->attemp_times = 0 info->active_slot = 0 info->slot_info[0].bootable = 1 info->slot_info[0].online = 1 info->slot_info[1].bootable = 0 info->slot_info[1].online = 0 info->attemp_times = 0 _find_partition_by_name()-188: do not find match in table misc Cannot find dev. amlmmc cmd failed store - STORE sub-system Usage: store store init flag store read name addr off|partition size read 'size' bytes starting at offset 'off' to/from memory address 'addr', skipping bad blocks. store write name addr off|partition size write 'size' bytes starting at offset 'off' to/from memory address 'addr', skipping bad blocks. store rom_write add off size. write uboot to the boot device store erase boot/data: erase the area which is uboot or data store erase partition : erase the area which partition in u-boot store erase dtb store erase key store disprotect key store rom_protect on/off store scrub off|partition size scrub the area from offset and size store dtb iread/read/write addr read/write dtb, size is optional store key read/write addr read/write key, size is optional store mbr addr update mbr/partition table by dtb [burnup]Err:store_write_ops,L110:cmd [store write misc 0x73e9f470 0x0 0x440] failed attemp_times = 0 active slot = 0 wipe_data=successful wipe_cache=successful upgrade_step=2 [OSD]load fb addr from dts [OSD]fb_addr for logo: 0x7dc00000 [OSD]load fb addr from dts [OSD]fb_addr for logo: 0x7dc00000 [CANVAS]addr=0x7dc00000 width=3840, height=2160 amlkey_init() enter! [EFUSE_MSG]keynum is 4 [BL31]: tee size: 0 [KM]Error:f[key_manage_query_size]L507:key[usid] not programed yet [KM]Error:f[key_manage_query_size]L507:key[mac] not programed yet [KM]Error:f[key_manage_query_size]L507:key[deviceid] not programed yet "Synchronous Abort" handler, esr 0x96000210 ELR: 77ef6ae4 LR: 77ef6acc x0 : 0000000000000004 x1 : 0000000021a40d02 x2 : 000000000021a40d x3 : 0000000000000003 x4 : 0000000000000067 x5 : 0000000000000067 x6 : 000000000100bc82 x7 : 0000000000000044 x8 : 0000000000000001 x9 : 0000000000000000 x10: 0000000000000000 x11: 0000000000000000 x12: 0000000000000000 x13: 0000000000000000 x14: 0000000000000000 x15: 0000000000000000 x16: 0000000000000000 x17: 0000000000000000 x18: 0000000073e9fe28 x19: 0000000000000014 x20: 0000000000000000 x21: 0000000000000002 x22: 0000000000000003 x23: 0000000077f70f68 x24: 0000000000000000 x25: 0000000000000000 x26: 0000000000000000 x27: 0000000073eb8e80 x28: 0000000000000000 x29: 0000000073e9f7e0 Resetting CPU ... resetting ... GXL:BL1:9ac50e:bb16dc;FEAT:ADFC318C:0;POC:3;RCY:0;EMMC:0;READ:0;0.0;CHK:0; ... repeats