# Pastebin BnyDKYOm
U-Boot 2018.05 (May 07 2018 - 15:32:36 +0000)

DRAM:  2 GiB
In:    pl011@9000000
Out:   pl011@9000000
Err:   pl011@9000000
Net:   No ethernet found.
Hit any key to stop autoboot:  0 
scanning bus for devices...
Target spinup took 0 ms.
SATA link 1 timeout.
SATA link 2 timeout.
SATA link 3 timeout.
SATA link 4 timeout.
SATA link 5 timeout.
AHCI 0001.0000 32 slots 6 ports 1.5 Gbps 0x3f impl SATA mode
flags: 64bit ncq only 
  Device 0: (0:0) Vendor: ATA Prod.: QEMU HARDDISK Rev: 2.5+
            Type: Hard Disk
            Capacity: 40960.0 MB = 40.0 GB (83886080 x 512)

Device 0: (0:0) Vendor: ATA Prod.: QEMU HARDDISK Rev: 2.5+
            Type: Hard Disk
            Capacity: 40960.0 MB = 40.0 GB (83886080 x 512)
... is now current device
Scanning scsi 0:1...
load - load binary file from a filesystem

Usage:
load <interface> [<dev[:part]> [<addr> [<filename> [bytes [pos]]]]]
    - Load binary file 'filename' from partition 'part' on device
       type 'interface' instance 'dev' to address 'addr' in memory.
      'bytes' gives the size to load in bytes.
      If 'bytes' is 0 or omitted, the file is read until the end.
      'pos' gives the file byte position to start reading from.
      If 'pos' is 0 or omitted, the file is read from the start.
=>